Support

If you have a problem or need to report a bug please email : support@dsprobotics.com

There are 3 sections to this support area:

DOWNLOADS: access to product manuals, support files and drivers

HELP & INFORMATION: tutorials and example files for learning or finding pre-made modules for your projects

USER FORUMS: meet with other users and exchange ideas, you can also get help and assistance here

NEW REGISTRATIONS - please contact us if you wish to register on the forum

PWM to Com Port

For general discussion related FlowStone

Re: PWM to Com Port

Postby Radian » Tue Jan 25, 2011 4:39 pm

Thank you DSP.
I don't want to be a pain in the §$%& but I think the accuracy is only needed on the receiving side via the hall sensor to the soundcard.
If rpm drops the solenoid just needs to get more pulses that cause more diesel to be injected until it's up to the specified rpms again. No need to keep a pre-defined PWM count.
To much rpm calls for less pulses than the current PWM rate
To less rpm calls for more pulses than the current PWM rate

The com port has the advantage to trigger the TTL level of the Transistor on the SSR without any further circuitry while the soundcard output needs a boost from the usual 2-3V RMS.

On the other hand the com port module to me looks really complicated to configure
Are there any example schematics on how to get pulses out of the com port?

Greets,
Radian
Radian
 
Posts: 4
Joined: Wed Jan 19, 2011 10:14 pm

Previous

Return to General

Who is online

Users browsing this forum: No registered users and 48 guests