Sound Card detection?
Posted: Thu Dec 15, 2011 7:49 pmHow can I detect my sound card to control volume using flowstone?
DSP Robotics Support
DSP Robotics and FlowStone Graphical Programming Software Support and Forums
http://www.dsprobotics.com/support/
Sound Card detection?
Page 1 of 1
Posted: Thu Dec 15, 2011 7:49 pmRe: Sound Card detection?
Posted: Thu Dec 15, 2011 8:42 pmyou have to load asio and/or direct sound modules then you can use the audio selector module to select the proper audio card
Re: Sound Card detection?
Posted: Thu Dec 15, 2011 11:16 pmwhere and how do I load them? I added ASIO and the wrench icon would not open?
Re: Sound Card detection?
Posted: Fri Dec 16, 2011 1:16 amthe wrench can be used to open the asio control panel of the selected audio card, but an audio card must be selected first.
If you don't see your audio card listed inside the asio module, it's because your card doesn't have asio support, so you should use the direct sound module or install asio for all driver from here.
I have attached a project to look inside.
If you don't see your audio card listed inside the asio module, it's because your card doesn't have asio support, so you should use the direct sound module or install asio for all driver from here.
I have attached a project to look inside.