Help setting up PhantomX Reactor Robot Arm
Posted: Fri Mar 01, 2013 1:16 am
Hello!!
We recently bought the PhantomX Reactor Robot Arm Kit, after assembling it I am trying to get it to work but no luck so far. I pretty much followed the instructions to download Flowstone, arbotix & arduino, after uploading the firmware as mentioned in this link http://code.google.com/p/arbotix/wiki/GettingSetup, i was able to get some response from the arm using pypose.py.
When i run pypose in terminal mode this is what I am getting:
>> valid commands
>> ls
1 2 3 4 5 6 8
>> pos
>> baud
>> temp
Other than ls no other command is responding. i would really appreciate if some one could throw some light on what I am doing wrong?
Thanks in advance for your help.
Regards
Tanmoy
We recently bought the PhantomX Reactor Robot Arm Kit, after assembling it I am trying to get it to work but no luck so far. I pretty much followed the instructions to download Flowstone, arbotix & arduino, after uploading the firmware as mentioned in this link http://code.google.com/p/arbotix/wiki/GettingSetup, i was able to get some response from the arm using pypose.py.
When i run pypose in terminal mode this is what I am getting:
>> valid commands
>> ls
1 2 3 4 5 6 8
>> pos
>> baud
>> temp
Other than ls no other command is responding. i would really appreciate if some one could throw some light on what I am doing wrong?
Thanks in advance for your help.
Regards
Tanmoy